Key takeaways
Choose USDT and the network at the destination first, then mirror that full route at the source.
A deposit address, token contract, TXID, and Memo/Tag are four different data items and are not interchangeable.
Recipient of this transfer
Paste into the source address fieldChain where the asset is recorded
Full names must match at both endsAccount identifier under a shared address
Enter only when displayed; never omit itUSDT identity on one chain
Verify the token; do not use it as recipientSeparate the four strings shown on the page
The deposit address is the recipient for this transfer and belongs in the source address field. A token contract identifies USDT on a particular chain; it is not your receiving address. A TXID is the transaction identifier created only after a transfer is sent.
A Memo/Tag is a second identifier some platforms use to assign a transfer sent to a shared address to a specific account. When the deposit page displays one, address and Memo/Tag must be entered as a pair; when it displays none, do not invent one.
A familiar-looking address does not prove the network
USDT exists on multiple chains, each with its own ledger and token identity. Several EVM networks can display the same 0x address. That indicates compatible address formatting or key derivation, not that the destination monitors and credits every such chain.
The actionable proof is an exact match between the full network name currently listed by the destination and the source confirmation screen. Prefixes, fee levels, and automatic detection are aids, not substitutes for that match.
Build the route backward from the destination
First, choose USDT and a currently open network on the official destination deposit page. Second, record the address, any Memo/Tag, the minimum deposit, and confirmation requirement together. Third, select the identically named network at the source and compare the address ends and Memo/Tag again after pasting.
The fourth step is not immediate submission. On the final screen, confirm that the actual received amount exceeds the destination minimum. For a new route, send an affordable but valid test first; after the destination balance really increases, reopen the deposit page before sending the remainder.
Stop when any of these signals appear
Cancel if the destination does not list the source network, the source lacks a required Memo/Tag field, the pasted address ends change, the final received amount is below the deposit minimum, or either endpoint is under maintenance.
The most deceptive case is “the address looks right, so it should arrive.” Do not test ambiguity with an even smaller amount. Rebuild the route at the destination; if a complete match is impossible, use another network supported by both endpoints.
FAQ
Can I reuse an address from a screenshot?
Avoid it. Sign in to the destination and confirm the current address.
Is a deposit address the same as the USDT contract address?
No. A deposit address receives your funds; a contract address identifies the token. Sending to a token contract can cause loss.
Must I check a network after automatic detection?
Yes. Automatic detection is only an aid; compare it with the full network name and deposit instructions.
Why does one platform give me several deposit addresses?
Different networks use different addresses, which is expected. Some platforms also rotate addresses within a network or assign them per sub-account. What warrants caution is an address that differs from your last one on the same network and that you cannot reproduce inside the official app.
Sources and verification
Sources prioritize protocol, network, and exchange documentation. External pages can change; signed-in confirmation screens remain authoritative for fees and account status.
- OKXHow to find a deposit address and tag/memo/commentChecked 2026-09-04
- OKXWhy a deposit has not been creditedChecked 2026-09-04
- BinanceHow to deposit and withdraw cryptocurrencyChecked 2026-09-04
- TetherTether supported protocols and contractsChecked 2026-09-04